«
»

Software RAID Recovery
To simulate disk failure
# mdadm /dev/md0 -f /dev/sda1
Recovering from a software RAID disk failure
1.
Replace and reboot, or hot-remove if hardware supports it
# mdadm /dev/md0 -r /dev/sda1
2.
Add replacement partition into array
# mdadm /dev/md0 -a /dev/sda1
To disassemble/stop a disk array
# mdadm -S /dev/md0

This entry was posted by admin on August 11, 2010 at 11:04 am under linux. You can leave a response, or trackback from your own site. Follow any responses to this entry through the RSS 2.0 feed.

Leave a Reply

You must be logged in to post a comment.